국가별 웹사이트
The DulcoFlow® flow meter measures all liquid media without any media contact. The rate of flow of non-continuous volume flows and the amount of liquid which has passed through in pulsing flow regimes are measured. Available from October 2010!
더보기
The new Mikro delta® series of metering pumps can also provide continuous and high-precision metering of even the smallest quantities thanks to their regulated drives.
DULCOTEST® sensors for the measurement of free chlorine at higher pH values of up to 9, temperatures of up to 70°C and pressures of up to 8 bar. The new membrane-free amperometric DULCOTEST® type CLO1 and CLO2 sensors extend the range of membrane-covered chlorine sensors to include the following applications.
Lower operating and maintenance costs are only two of the many benefits of the new Dulcodes S UV system. It is a further addition to the existing range and is used specifically for the photochemical degradation of bonded chlorine (chloramine) in the treatment of swimming pool water.
용량 범위: 0.5 - 21.5 l/h, 10 - 4 bar 간단한 임무용 모터 구동형 다이아프램 정량 펌프. 이 펌프는 특별히 지속적인 정량 주입에 적합합니다.
The new electronics in the Beta® solenoid metering pump results in increased energy efficiency compared to the predecessor model.
ProMinent has added to its range of peristaltic pumps for low, medium and high delivery rates.
New metering heads comply with the most stringent hygienic requirements. Dependent on required capacity range motor- or solenoid-driven metering pumps will be employed. The proven Sigma motorised metering pumps and delta® diaphragm metering pumps with regulated solenoid drive form the basis of the pumps.
The motor pumps of the Sigma series are equipped with a patented multilayer safety diaphragm and a visual diaphragm rupture indicator. The multilayer safety diaphragm guarantees that no leakages to the outside occur if the diaphragm ruptures.
In addition to safety aspects, new standards are set in terms of size with the newly developed TriPower MF process diaphragm pump.
Ready-for-use, assembled, automatic 3-chamber preparation system for powdery flocculants to prepare a 0.05 - 0.5 % polymer solution.
In POLYMORE polymer preparation and metering systems, peristaltic pumps are used to deliver liquid polymer into a multi-zone mixing facility to the diluting water and are then processed into a homogeneous polymer solution.
The disinfection controller combines a measurement and control unit with sensors and actuators for the first time in drinking water treatment applications. The disinfection controller is specially built to deal with the specific requirements in drinking water treatment processes and, combined with various measurement and actuator modules, it is designed for flexible use.
This newly developed type D1Cb basic single-channel measurement and control unit can be used in drinking water, cooling water and boiler feed water treatment applications. The basic D1Cb is equipped for all the main measurement variables encountered in water treatment applications and features a calibration logbook.
Protection against corrosion and deposits in the cooling plant. Maximum efficiency of the cooling plant. Reduction of the chemicals need to a minimum.
The cooling tower controller AQUATRAC® Multiflex M10 can simultaneously control up to four cooling circuits or steam generators. All required functions such as conductivity-dependent desalination control, metering of two biocides and one inhibitor as well as the monitoring of the entire process can be implemented.
The new sensor type CLO 2 serves the monitoring of the disinfection parameter “free chlorine” in hot water circuits of up to 70 °C and at pressures of up to 8 bar. As compared to conventional systems, this becomes possible by returning the media to the process line. The water consumption can thus be reduced.
The design of the new chlorine dioxide sensor CDR 1- was modified such that it can be used especially also in polluted industrial, process and waste water as well as in cooling water applications or surfactant-polluted waters and also in irrigation waters for agriculture.
Its lower energy and cooling water consumption and compact design are key features of the new ozone generation plant OZONFILT® OZMa that generates 70 to 245 g of ozone per hour from compressed air or oxygen. The ozone volume can be set reproducibly and independently of voltage and pressure fluctuations.
Safely and cleanly into the future - chlorine dioxide systems Bello Zon® CDVc and CDKc are wired ready for connection and are used for the production, metering and monitoring of 20 to 7,500 g/h of chlorine dioxide. An innovative and completely newly developed reactor concept ensures the efficient production and metering of chlorine dioxide.
The extremely economic and compact chlorine dioxide plants SVP-Pure® produce and meter up to 200 kg/h of chlorine dioxide in a closed control cabinet.
The new electrolysis plants are a highly economic and at the same time a safe alternative to the storage or transportation of hazardous chemicals. The plants with economical salt and energy consumption are available as tubular cell electrolysis or as membrane electrolysis plant.
The reverse osmosis systems are equipped with the latest generation of ultra low pressure diaphragms. As a result, the systems achieve maximum permeate output at low operating pressures, thus keeping investment and operating costs low.
Dulcoclean® UF eco systems offer state-of-the-art ultrafiltration technology for removing all pathogens and turbidity in water. Integrated automatic diaphragm monitoring and user-friendly remote control ensure the compact small-scales systems effectively achieve an output rate of up to 3.9 m3/h with maximum safety and reliability.
에코프로 역삼투압 시스템은 고효율성과 뛰어난 가격/실행율을 제공합니다. 광물질이 제거된 식수는 보일러 보충수, 세척용과 청소용을 위한 자연수 또는 용수로서 사용되어 오던 곳 어디에서나 많은 공정들에서 없어서는 안될 필수품입니다.